Russound MCA-C5 - Manual (Page 16)

16 Russound MCA-C5 User and Installation Manual
MDK-C5 Color Plate Conversion
You will need both small straight and Phillips head screwdrivers to change
the color plates on the keypad. The Bezel Molding and the Trim Plate will be
switched for the new color plates.
If installed, remove the MDK-C5 keypad from the wall. Gently pull the Trim 1.
Plate off the mounting plate. Unscrew the unit from the electrical box,
and disconnect the cable.
Unscrew the plastic Frame Plate. Keep the Frame Plate and screws for 2.
reattachment later.
Remove the Display Lens from the Bezel Molding by providing inward 3.
pressure to the two locking tabs while simultaneously pushing it away
from the Bezel Molding.
Once the Display Lens is removed, put aside for reattachment later. Be 4.
careful to not damage the display.
VOL
VOL
HOME
MENU
Remove the Bezel Molding by gently pressing in each of the 4 locking tabs 5.
(2 per side) while pushing it away from the metal frame.
Reverse the order for installation, taking the following precautions. 6.
a. Make sure the button key mat is positioned properly on the front circuit
board and without dust or debris on the button contact points prior to
attaching the Bezel Molding.
b. Make sure that there isn’t any debris or fingerprints on either the display
or back of the Display Lens prior to reattachment.
c. Use a clean, dry, lint-free soft cloth to gently wipe the display or back
of the Display Lens to clean if necessary. Never use cleaning agents as this
can cause streaking or permanent damage to either part.
KEYpAd COLOR pLATE CONVERSION
Trim Plate
Screws
Frame Plate
Display Lens Bezel Molding
Metal Frame
Screws
Keypad Disassembly / Assembly