Radio Shack TAD-1026 - Manual (Page 25)

25
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The remote operation security code is
preset to 784, but you can change it by
following these steps.
Note: Be sure to set each digit within 8
seconds. Otherwise, you must start over
from Step 1.
1. Hold down CODE until the TAD
beeps once. Co appears.
2. Press CODE again. Sc (security
code) and the digits of the current
code appear in sequence, then the
first digit reappears.
For example, when the security
code is 784, the display shows
Sc
(security code), –7 , –8 , – 4 , then –7
reappears.
3. Repeatedly press CODE or
MEMO to set the first digit, then
press ANSWER . The second digit
appears.
Note: If you enter an incorrect digit,
press
STOP/T-SET , then start again
from Step1.
4. Press CODE or MEMO to set
the second digit, then press AN-
SWER . The third digit appears.
5. Press CODE or MEMO to set
the third digit, then press ANSWER .
The TAD sounds a long beep.
To check the remote operation security
code at any time, follow Steps 1 and 2,
then press
STOP/T-SET to exit.
34.epsi
43-786.fm Page 25 Monday, August 16, 1999 8:02 AM