Radio Shack TAD-1026 - Manual (Page 15)

15
To release the line from hold and
continue your phone conversation,
pick up the handset or another
phone’s handset that is on the same
line.
• Hold the handset or set it next to the
phone.
To release the line from hold and
continue your phone conversation,
press and release
FLASH or the
phone’s switchhook.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure T/P is set to P .
2. Dial the service’s main number.
3. When the service answers, press
TONE . Any additional numbers you
dial are sent as tone signals.
4. After you complete the call, hang up
the handset. The phone automati-
cally resets to the pulse mode.
MEMORY DIALING
You can store emergency phone num-
bers or phone numbers you most fre-
quently call in the three priority memory
locations for one-touch dialing. You can
store 10 more phone numbers in the in-
direct memory locations, then quickly
call the number by entering its memory
location number.
Each memory location can store up to 16
digits.
Storing a Number in Memory
1. Lift the handset.
2. Press STORE .
3. Enter the phone number you want
to store.
43-786.fm Page 15 Monday, August 16, 1999 8:02 AM