Roland BR-864 - Manual (Page 153)

153
Utility parameter list
Section 5
About the effects Insert mode
This section describes Insert mode.
1. Press [UTILITY].
2. Press CURSOR [ ] [ ] to move the cursor to “SYS,”
and press [ENTER].
3. Make the setting with the TIME/VALUE dial.
Insert Mode
Valid Settings:
INPUT, INPUT, TRACK 1–8,
TRACK 1&2–7&8, RHYTHM, MASTER
(Initial value: INPUT)
This sets the target to which the insert effects are applied.
You can use this setting to apply insert effects to sounds that
have already been recorded to the tracks.
INPUT:
Effects are applied to the input source. This mode is normally
set as the default.
fig.05-801
INPUT:
You can monitor the sound of the input source with the
effects applied, but only the dry sounds, without the effects
applied, are recorded.
fig.05-802
TRACK 1–8, TRACK 1&2–7&8:
Effects are applied to each of the selected tracks.
fig.05-803
RHYTHM:
Effects are applied to the Rhythm Guide sounds.
fig.05-804
MASTER:
Effects are applied to the sounds from the master output.
fig.05-805
TRACK 1
(REC)
TRACK 1
(REC)
TRACK 1
(PLAY)
Rhythm
Guide
TRACK 1
(PLAY)
TRACK 2
(PLAY)
TRACK 8
(PLAY)
Rhythm
Guide