Important – Renesas M302N2 User Manual

Page 13

( 11 / 38 )

IMPORTANT

Note on the Work Area:

• When using this product, set to "2C00h" as a start address of the work area at the time of starting

up the emulator debugger (set by "F/W and Work Area" tab*

of Init dialog). In this case, the

emulator system uses the area below as a work area.

02C00h - 02C0Fh: Work area

*1 Supported by M3T-PD30 Ver.4.00 or later

Note on Accessing SFR Area:

• Access the below four registers by byte. They cannot be correctly accessed by word.

003FCh:

Pull-up control register 0 (PUR0)

003FDh:

Up control register 1 (PUR1)

003FEh:

Port P1 drive capacity control register (DDR)

003FFh:

Up control register 2 (PUR2)

Note on Commands that Access the Single-step Interrupt Vector Area:

• Do not perform the below debugging operations with the single step interrupt vector area (addresses

FFFECh - FFFEFh).

(1) Step execution of commands that access the single step interrupt vector area

(2) Program execution using commands that access the single step interrupt vector area when a

software breakpoint is set in those commands

Note on MAP References and Settings:

• When starting up the M30200T-RPD-E, initial MAP settings are as follows. Use generally the

M30200T-RPD-E in this setting.

00000h to 003FFh: "EXT"

00400h to FFFFFh: "INT" (emulation memory available)

This manual is related to the following products: