Radio Shack 43-3870 - Manual (Page 8)

Installation
8
3. Insert the supplied AC adapter’s barrel plug
into the DC IN 9V jack on the back.
4. Route the adapter’s cord through the strain
relief slot on the base’s bottom.
5. Plug the adapter into a standard AC outlet.
6. Lift the base’s antenna to a vertical position.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need
two screws (not supplied) with heads that fit into the
keyhole slots on the base. Drill two holes 3
15 /
16
inches apart. Thread a screw into each hole, letting
the heads extend about
1 / 8 inch.
1. Plug one end of the supplied modular cord
(short for a wall plate, long for direct wall
mounting) into the
TEL LINE jack on the base’s
back.
2. Insert the
supplied AC
adapter’s barrel
plug into the
DC
IN 9V jack.
3. Route the
adapter and
modular cords
through the
base’s grooves.
4. For a wall plate ,
plug the modular cord’s other end into the wall
plate jack, then align the base’s keyhole slots
with the wall plate studs and slide the base
downward to secure it.
TEL LINE
DC IN 9V
43-3827/3870.FM Page 8 Monday, June 2, 2003 11:02 AM