Radio Shack ET-929 - Manual (Page 18)

18
Editing or Deleting a Memory
Number
1. Lift the handset. If appears,
press TALK to turn it off.
2. Press FUNCTION . DIAL MEMORY?
and MEM-1 EDIT-0 appear.
3. Press 0 to select EDIT . LOCA-
TION? appears.
4. Enter the memory location number
(01-20) for the number you want to
edit or delete. The display shows
the location number, name, and
phone number.
Note: You can scroll through the
memory locations by pressing s or t.
5. To delete the selected number, hold
down
DELETE until the handset
beeps and No memory appears.
To edit the number, press MEM . Re-
peatedly press DELETE to delete
some or all of the number, then en-
ter the new number (in reverse or-
der) and press
MEM again.
Note: To edit the name without edit-
ing the number, simply press
MEM
twice.
To edit the name, use the s, t, ,
and keys as described in Step 6
of “Storing a Number and Name in
Memory” on Page 17.
6. Press MEM . STORING briefly ap-
pears.
Entering a Pause
In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. You can
store the access code with the phone
number. However, you should also store
a pause after the access code to allow
the outside line time to connect.
To enter a 2-second pause while storing
a phone number, press
PAUSE . P ap-
pears. You can add more pause entries
for a longer pause.
Dialing a Memory Number
1. Lift the handset and press TALK , so
appears.
2. Press MEM and enter the memory
location number (01-20) for the
number you want to dial.
You can also select a memory number
before you press
TALK . Press MEM ,
then enter the desired location number,
or use s and t to scroll through the mem-
ory locations. The display shows the lo-
cation number, name, and phone
number. Then press
TALK .
talk
talk
43-1099.fm Page 18 Tuesday, August 17, 1999 4:19 PM