Roland PICZA LPX-60 User Manual
Page 24
22
2-4 Installing and Setting Up the Software
2. Preparing the Machine
Windows 2000
1
Before you start installation, make sure the machine
and your computer are not connected by the USB
cable.
2
Start Windows and log on as "Administrator."
3
Insert the Roland Software Package CD-ROM into
the CD-ROM drive.
The window shown in the figure appears automati-
cally.
4
Switch on the machine.
Wait a short while until the lights stop flashing.
The flashing continues for about one minute.
From this point on, keep the door closed until installa-
tion ends. Failure to do so switches off the power, which
may prevent installation from completing correctly.
5
Connect the included USB cable.
The [Found New Hardware Wizard] dialog box ap-
pears.
6
Click [Next].
USB connector USB cable
These lights flash clockwise
two at a time.
Press the power button.
Computer
USB port
The back of
the machine