Radio Shack 2.4 GHz Digital Spread Spectrum Cordless Telephone with Caller ID/Call Waiting - Manual (Page 18)

18 Operation
Entering a Pause
In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect. To enter a 2-second pause, press
RDL/
PAUSE . P appears. You can add more pause
entries for a longer pause.
Reviewing Memory Numbers
To review your memory numbers, press
MEM . The list of memory location numbers
(01-20) appears with the name stored with
each number (or
nn> if you did
not store a name).
To see the stored phone numbers, press #/
7
. An arrow to the right of the number
means it is longer than 13 digits. Press #/
7
again to see the rest of the number. Repeat-
edly press
TONE/
6
/ to return to the name
display.
To exit the memory number list, press MEM .
To see a stored name and phone number at
the same time, press
SELECT/CHANNEL
when the cursor is by a memory location
number. To exit this display, hold down
DEL
until the display clears.
Dialing a Memory Number
To dial a number stored in memory, lift the
handset and press
MEM . The list of memory
location numbers appears. Choose a memo-
ry location (
01 – 20 ) by pressing a number or
by repeatedly pressing VOL/CID
8
or
9
,
then press TALK .
You can also dial a memory number after
pressing
TALK . Press MEM (the display does
not change but the phone's memory recall
activates) then enter a memory location
number.
Chain-Dialing Service Numbers
For quick recall of numbers for special ser-
vices (such as bank-by-phone), store each
group of numbers in its own memory loca-
tion. Dial the service's main number first.
Then, at the appropriate place in the call,
press
MEM and enter the number for the lo-
cation where the additional information is
stored.
Testing Stored Emergency Num-
bers
If you store an emergency service's number
(police department, fire department, ambu-
lance) and you choose to test the stored
number, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Also, remain on the line to
explain the reason for your call.
USING A HEADSET
You can make or answer calls with hands-
free convenience using an optional headset
that has a
3
/ 32 -inch (2.5-mm) plug. Contact
your local RadioShack store for a suitable
headset.
To connect the headset, pull open the rubber
cover marked
on the side of the handset,
then insert the headset's plug into the jack.
43-5521.fm Page 18 Monday, June 5, 2000 12:29 PM