Ricoh G413 - Manual (Page 34)

VRS Getting Started Guide
30 Kofax Image Products
! To change the Skew tab settings
1 From the VRS Interactive Properties dialog box, select the Skew tab.
2 Adjust the movable angle control arm until the image is straight:
a
Use the mouse to select the vertical arm. When selected, the pointer changes to a hand
icon.
b Move the arm counter-clockwise to rotate the image to the left, or clockwise to rotate
it to the right. The Angle setting changes as the image rotates; the valid range is -45
degrees to 45 degrees.
3 In the Angle box, you have two ways to adjust the Angle setting:
a
Place your cursor in the Angle box, click the arrows to review the list of settings, and
click your selection.
b
Type a value for the correction angle directly into the Angle box.
The valid range for the angle is -45 degrees to 45 degrees.
4 Using the Fine Angle Adjustment Slider, you can fine-tune the deskew angle in single
degree, or partial degree, increments, as follows:
a By moving the slider all the way to the left, you select a complete one-degree, counter-
clockwise angle adjustment.
b By moving the slider all the way to the right, you select a complete one-degree,
clockwise angle adjustment.
c By moving the slider to a position in between the leftmost or rightmost setting, you
select an angle shift that is less than a full degree. Each line on the slider scale
represents 5 percent of one degree.