Ryobi RY08554 - Manual (Page 9)

9
ASSEMBLY
UNPACKING
This product requires assembly.

Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Blower
Upper Blower Tube
Sweeper Nozzle
High Velocity Nozzle
Vacuum Handle
Vacuum Handle Knobs ()
Grounding Wire
Upper and Lower Vacuum Tubes
Vacuum Tube Screws ()
Vacuum Bag Assembly
Vacuum Bag Adaptor
-Cycle Engine Lubricant
Operator’s Manual
NOTE: Read and remove all hang tags and store with your
operator’s manual.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
 Align raised tabs on main housing to the slots on upper
tube; slide together and tighten securely by twisting.
Check tightness after initial run and retighten if needed.
 To remove the tubes, rotate the tubes to unlock them and
remove from the blower housing outlet.
Fig.
Fig. 3
SWeeper noZZle
upper bloWer
Tube
GROUNDING INSTRUCTIONS
See Figure 3.
Before installing the vacuum handle, connect the grounding
wire as shown. This will help prevent static shock when using
the vacuum in low humidity conditions.