RCA VR618HF - Manual (Page 37)

35
References
Trouble Checks
Trouble Here's what to try:
Streaks in picture during normal playback
Will not record
Rewind does not operate
VCR Plus+ or timer recording not made
or wrong program recorded
Clock shows incorrect time or date
VCR makes noise when stopped
Will not auto channel search active
channels correctly
Cannot select channels over 69
Cassette with safety tab removed does not start to
play automatically
Displays appear in wrong language
Stereo or SAP sound not recorded
No stereo sound during playback
Stereo audio too noisy
• Some snow/streaks are normal during search, frame advance, slow-motion,
or stop-action playback.
• VCR is in pause mode. Press PAUSE.
• Safety tab removed from cassette.
• Make sure the line indicator (L1) is turned off in VCR’s display panel for
normal recording from the VCR’s tuner. Press INPUT to turn off the line
indicator.
• Tape already rewound.
• Wrong PlusCode number entered.
• Cable box was not turned on or was tuned to the wrong channel at time
recording was to begin.
• Program entered incorrectly (wrong channel or times).
• Power interruption. Clock area in display panel will show - -:- -.
• Check to see if time and date are correct — including AM/PM.
• Program exceeded tape’s length or tape was not rewound beforehand.
• VCR was not turned off at the time recording was to start.
• No tape in VCR or cassette’s safety tab broken off.
• Power interruption. Clock on the front panel will show --:--.
• Clock was not set accurately (check AM/PM and date).
• Time counter display appears in VCR’s display panel. Press DISPLAY on
remote.
• VCR is removing tape from heads. This is normal. The head cylinder inside
the VCR will continue to rotate for a few minutes after you put the VCR in
the stop mode.
• Check antenna connections.
• Check Signal Type: CABLE/ANTENNA feature. See page 8.
• Cable channels over 69 can only be selected if Signal Type:
CABLE/ANTENNA feature is set to CABLE. Details are on page 8.
• Set Auto Play ON/OFF feature to ON. Details are on page 15.
• Language feature set incorrectly. Details are on page 9.
• Reception: STEREO/SAP/MONO feature must be set to STEREO to record
broadcast stereo. See page 28.
• Reception: STEREO/SAP/MONO feature must be set to SAP to record SAP.
See page 28.
• STEREO indicator not on. Station not broadcasting stereo.
• Tape Playback: HI-FI/LINEAR/MIX feature must be set to HI-FI to hear stereo
sound during playback. See page 15.
• An advanced hook-up must be used for stereo playback. See pages 3-6.
• Stereo signal is weak. Set Reception: STEREO/SAP/MONO feature to
MONO .
• Press one of the TRACKING up or down buttons to minimize the noise.