Runco CL-500 - Manual (Page 19)

4. Basic Operation
User’s Manual
15
4. Basic Operation
Turning on the Power
Zoom/ Focusing
Selecting Input Source
■ The Power LED lights orange when power is
applied and the power switch is turned on.
■ Press and hold the ON key on the remote control
for ONE second to turn on the unit. The POWER
LED will blink orange during warm up period, then
light solid green.
■ " Searching…." will be displayed on the screen
before the projector identifies the input signal. This
message will remain on the screen until a valid
signal is detected.
■ If the horizontal frequency of the input signal
exceeds the range of the projector (XGA), a " Not
supportive timing " message will be displayed on the
screen. This message will remain on screen until
you change the input signal.
■ Adjust the projection image size you need with the
zoom ring on the lens. To focus the image, rotate the
focus ring on the lens.
■ When this unit is turned on, it will search for the
input source you selected last time.
■ You may select the input source directly on the
remote control.
ON
VIDEO S-VIDEO COMPONENT
COMPONENT HD RGB HD PC
OFF
Zoom in
Focus
Zoom out
Focus
Zoom in Zoom out
S-VIDEO COMPONENT VIDEO
COMPONENT HD RGB HD PC