RCA DRC233N - Manual (Page 9)

Connections and Setup
7
Graphics throughout this User’s Guide are for representation only.
Connection: DVD + TV + VCR
1. Connect the audio cables to the AUDIO OUT L (left – white) and R (right – red) jacks on
the back of your DVD Player, and to the corresponding Audio Input jacks on your TV
(sometimes labeled AUDIO INPUT L and R).
2. Connect the video cable.
Basic video connection – Connect the video cable (yellow) to the VIDEO OUT jack on
the back of your DVD Player, and to the Video Input jack on your TV (sometimes labeled
VIDEO INPUT).
Note: If your TV has an S-Video jack, connect the S-Video cable (not provided) to the
S-VIDEO OUT jack on the back of your DVD Player and to the S-VIDEO jack on your TV.
– OR –
If your TV has component video jacks (Y, Pb, Pr), use video-grade cables (not provided) to connect the
TV to the DVD player’s COMPONENT VIDEO OUT (Y, Pb, Pr) jacks. It is essential to match the color
coded connectors with a compatible TV.
If you have a Progressive Scan TV, you must use the Component Video connection (Y, Pb, Pr), and
activate Progressive Scan by pressing the PREV/VIDEO button on the front of the DVD player (for
instructions, go to page 35).
3. Connect the antenna or cable to the Antenna Input jack on the VCR (sometimes labeled IN
FROM ANTENNA).
Note: Connecting a VCR is optional. It is shown in this connection diagram since most households
have a VCR connected to the TV.
4. Connect a coaxial cable to the Antenna Output jack on the VCR (OUT TO TV) and to the
Antenna Input jack (IN FROM CABLE/ANTENNA) on the TV.
5. Insert the AC power cord into an AC outlet.
Go to page 8
More Information about Progressive Scan
Some high-end HDTVs and multimedia monitors offer progressive scanning of the video
signal instead of interlace. Proponents of Progressive Scan say it provides a crisper picture
because it eliminates the “flicker” or “jitter” at the edges of the screen.Your DVD player is
equipped to send a progressive scan signal, but you must connect the DVD player via the
COMPONENT jacks (Y, Pb, Pr) to a Progressive Scan TV or monitor, AND you must activate
Progressive Scan by pressing the PREV/VIDEO button on the front of the DVD player (for
instructions, go to page 35).
Note: If your TV doesn’t have Audio and Video Input Jacks and only has an RF jack, you need
to connect an RF modulator (not provided). For information, go to page 41.