RCA VR546 - Manual (Page 8)

Chapter 1: Connections & Setup
6 Chapter 1
TV + VCR + Satellite Receiver
1. Connect the VCR to the TV
A. Connect one end of the supplied RF coaxial cable to the RF OUT jack on the back of
the VCR and the other end to the TV’s antenna in jack.
– OR –
B. Connect audio/video cables to the AUDIO OUT R and L jacks on the back of the VCR
(color coded, red and white), and the VIDEO OUT jack (yellow). Connect the other
ends of the cables to the corresponding input jacks on the TV (sometimes labeled
VIDEO, AUDIO L/MONO, and AUDIO R).
2. Connect satellite receiver to the VCR
A. Connect an RF coaxial cable to the RF output jack on the satellite receiver and to the
ANT. IN jack on the VCR.
– OR –
B. Connect audio/video cables to the AUDIO IN R and L jacks on the back of the VCR
(color coded, red and white), and the VIDEO IN jack (yellow). Connect the other ends
of the cables to the corresponding output jacks on the satellite receiver (sometimes
labeled VIDEO, AUDIO L/MONO, and AUDIO R).
3. Connect the antenna to your satellite receiver
If necessary, connect an antenna or cable box RF coaxial cable (not included) to the
antenna input jack on the satellite receiver.
4. Connect the satellite feed to the satellite receiver
Connect the satellite receiver’s RF coaxial cable feed (not included) to the satellite input
jack on the satellite receiver.
Go To Page 8
VC
R
TV
Sa
tel
lite
CABLE/
ANTENNA
VCR
TV
VIDEO
R L / MONO
S-VIDEO
AUDIO
L
IN
OUT
CH3
CH4
S-VIDEO
L R VIDEO
OUT
IN FROM ANT
OUT TO TV SATELLITE
IN
From
Satellite
From Cable
or TV Antenna
ANT. IN
RF OUT
VIDEO
AUDIO
OUT IN
R
L
SATELLITE
RECEIVER
3
2A
1A
4
The back of your TV might not look
exactly like the one shown here.
The back of your satellite receiver
might not look exactly like the one
shown here.
1B
2B
The VCR pictured here is model
VR637HF and shows stereo audio
jacks. Model VR546 is mono and
will not have separate left and
right audio jacks. Use connection
1A and 2A for model VR546.