Radio Shack ET-652 - Manual (Page 9)

9
CONFIRMING THE LINE
NUMBERS
Follow these steps to determine which
phone number is connected to which
line.
1. Press LINE 1 , then lift the handset.
2. Dial one of your phone numbers. If
the LINE 2 indicator flashes, the
number is connected to Line 2. If
you hear a busy signal, the number
is connected to Line 1.
After you confirm the phone number for
each line, write the number on the num-
ber card above the line-status indicator.
(Use a paper clip to lift off the card’s
cover.)
CHECKING/ADJUSTING
THE LINE-STATUS
INDICATORS
You can check the status of each line by
glancing at the line-status indicators.
Each line-status indicator is preset to
work correctly with most telephone lines.
However, in some cases you may need
to adjust the indicators to ensure correct
operation.
Follow these steps to test and adjust the
line-status indicators.
1. Press LINE 1 , then lift the handset.
The LINE 1 indicator should light
steadily.
2. Press HOLD . The indicator should
flash slowly.
3. If the indicator worked correctly, it
does not need adjustment. Other-
wise, proceed to Step 4.
VOLUME
MIN
MAX
LI NE 1- RINGE
R - LI NE 2
OFF LO HI
OFF LO HI
MODE
PULSE -
TONE
NORM -
STORE
Indicator is: Line is:
Not lighted Not in use
Lighted In use
Flashing rapidly Ringing
Flashing slowly On hold
43-652.fm Page 9 Friday, August 13, 1999 11:00 AM