Radio Shack ET-652 - Manual (Page 13)

13
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse dialing, you can still use these spe-
cial tone services by following these
steps.
1. Be sure MODE is set to PULSE .
2. Call the service’s main number.
3. When the service answers, press .
Any additional numbers you dial are
sent as tone signals.
4. When you hang up, the phone auto-
matically resets to pulse mode.
MEMORY DIALING
You can store up to 20 phone numbers
and names in memory, then dial a stored
number by entering a two-digit memory
location number. Each number can con-
tain up to 16 digits.
1. Set NORM/STORE on the right side
of the phone to STORE .
2. Press the line button for an available
line.
3. Lift the handset or press SPEAKER ,
then press MEMORY .
4. Set VOLUME to the middle setting,
then enter the number and any tone
and pause entries (see "Using Tone
Services on a Pulse Line" on this
page and “Entering a Pause” on
Page 14).
Note: Each tone or pause entry us-
es one digit of memory.
5. Press MEMORY , then enter a two-
digit memory location number (01–
20).
6. To store additional numbers, press
MEMORY again, then repeat Steps 4
and 5.
VOLUME
MIN
MAX
LI NE 1- RINGE
R - LI NE 2
OFF LO HI
OFF LO HI
MODE
PULSE -
TONE
NORM -
STORE
VOLUME
MIN
MAX
LI NE 1- RINGE
R - LI NE 2
OFF LO HI
OFF LO HI
MODE
PULSE -
TONE
NORM -
STORE
VOLUME
MIN
MAX
LI NE 1- RINGE
R - LI NE 2
OFF LO HI
OFF LO HI
MODE
PULSE -
TONE
NORM -
STORE
43-652.fm Page 13 Friday, August 13, 1999 11:00 AM