Radio Shack 43-329 - Manual (Page 47)

4
Ad
dit
io
na
l I
nfo
If the caller’s voice is very soft, the answering system might stop
recording and disconnect the call.
The answering system does not respond to remote commands.
Make sure your remote code is correct (page 15).
Make sure you are calling from a touch-tone telephone. When dialing a
number, there should be tones. If there are clicks, then it is not a touch-
tone telephone and cannot activate the answering system.
The answering system might not detect the remote access code when
your announcement is playing. Wait until the announcement is over
before entering the code.
There might be interference on the telephone line you are using. Press
the dial pad keys firmly when dialing.
Common cures for electronic equipment.
If the telephone is not responding normally, put the cordless handset in
the telephone base. If it does not respond, try the following (in the order
listed):
Disconnect the power to the telephone base.
Disconnect the battery on the cordless handset.
Wait a few minutes before connecting power to the telephone base.
Re-install the battery and place the cordless handset in the telephone
base or charger.
Wait for the cordless handset to synchronize with the telephone base.
Allow up to one minute for this to take place.
Important Safety Instructions
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury,
including the following:
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use
liquid or aerosol cleaners. Use a damp cloth for cleaning.
Do not use this product near water.
Do not place this product on an unstable table, shelf, stand or other
unstable surfaces.
Slots and openings in the back or bottom of the telephone base and
handset are provided for ventilation. To protect them from overheating,
•
•
•
•
•
•
•
•
•
•
•
1.
2.
3.
4.
.
.