Radio Shack 43-329 - Manual (Page 46)

4
Ad
di
ti
on
al
I
nf
o
Reset your telephone by unplugging the power adapter from the
telephone base. Disconnect the battery from the cordless handset. Wait
for 15 seconds, then plug in the power adapter and re-install the battery.
Place the handset in the telephone base and allow up to one minute for
the handset and telephone base to synchronize.
Other electronic products might prevent your handset and telephone
base from communicating with each other. Install your telephone base
as far away from these electronic devices as possible: wireless routers,
radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless telephones.
The answering system does not answer after the number of rings that I
programmed it.
Make sure the answering system is on. When the answering system is
on, the ANS ON/OFF light on the telephone base should be lit and
ANS ON should show on the handset.
If toll saver is selected, the number of rings changes to two when there
are new messages waiting (page 15).
If the memory is full or if the answering system is off, the answering
system answers after 10 rings.
In some cases, the answering system is affected by the ringing system
used by the local telephone company.
The outgoing announcement is not clear.
When recording the announcement, make sure you speak in a normal
tone of voice towards the microphone of the handset.
Make sure there is no background noise when recording.
The messages on the answering system are very difficult to hear.
Press VOL on the telephone base or handset to increase the speaker
volume.
The answering system does not record messages.
Make sure the answering system is on.
When the answering machine memory is full, it does not record new
messages until some old messages are deleted.
The messages on the answering system are incomplete.
If a caller leaves a very long message, part of it might be lost when the
answering system disconnects the call after four minutes.
If the memory on the answering system becomes full during a message,
the answering system stops recording and disconnects the call.
•
•
•
•
•
•
•
•
•
•
•
•
•