Radio Shack ET-1755 - Manual (Page 7)

7
5'66+0)"6*'"&+#.+0)"/1&'
Set TONE/PULSE on the bottom of the phone for the type of
service you have. If you are not sure which type you have,
do this simple test.
1. Set TONE/PULSE on the bottom of base to TONE .
2. Lift the handset, or press SPEAKER/HEADSET to listen
for a dial tone.
3. Press any number other than 0 .
±
#&,756+0)"6*'"4+0)'4"
81.7/'
Your phone has three ringer volume levels — high, medium,
and low. Repeatedly press
VOLUME
Vý
or
Wý
to adjust the
volume level, even when a line is ringing.
/#-+0)1#059'4+0)"%#..5"
9+6*"6*'"*#0&5'6
To make a call, pick up the handset and select a line by
pressing
LINE 1 , LINE 2 , or LINE 3 . When you hear the dial
tone, dial the number.
When you receive a call on a line, the indicator for that line
flashes and the phone rings. To answer the call, pick up the
handset and the phone automatically selects the ringing
line.
To help you tell which line is ringing, each line has a
distinctive ring tone. LINE1 has a higher tone than LINE 2
and LINE 3.
±
75+0)"6*'"52'#-'42*10'
To make or answer a call using the speakerphone, press
SPEAKER/HEADSET . The SPEAKER indicator lights and the
phone automatically selects a free line or the line that is
ringing. Or, you can also make or answer a call by pressing
LINE 1 , LINE 2 , or LINE 3 to turn on the speakerphone. The
SPEAKER indicator lights.
To end a speakerphone call, press SPEAKER/HEADSET .
The SPEAKER indicator turns off.
±
"016'"
±
"
• If your phone system requires
that you dial an access code (9,
for example) before you dial an
outside number, do not press
that number.
• If the dial tone stops, you have
touch-tone service. Leave
TONE/PULSE set to TONE. If
the dial tone continues, you
have pulse service. Set TONE/
PULSE to PULSE.
±
"016'"
±
"
• The phone automatically selects
the free line if you do not press
LINE 1, LINE 2, or LINE 3.
• When you receive a call on a
line, the phone automatically
selects the line that is ringing. If
three lines are ringing at the
same time, the phone selects
LINE 1 as priority.
• When one line is in use, and the
other line is ringing (for
example, LINE 1 is in use and
LINE 2 is ringing), the LINE 1
automatically sounds two short
beeps once to remind you the
LINE 2 is ringing.
• LINE 2 and LINE 3 do not
operate during a power failure.