Radio Shack ET-1755 - Manual (Page 4)

4
1
0
"
#
"&
'5-
1. Insert the mounting bracket’s
four tabs into the slots on the
bottom of the base then slide up
to snap the mounting bracket
into place.
2. If you have a two-line phone jack
and a one-line phone jack, plug
one end of the supplied two-line
long modular cord into
LINE L1/
L2 on the bottom of the base,
and plug one end of the supplied single-line long
modular cord into
L3 . Then route both line cords
through the left and middle slots on the mounting
bracket.
If you have three single-line phone jacks, you can
connect two lines with an optional two-line coupler.
Plug one end of the two-line cord into
LINE L1/L2 , and
the other end into the coupler’s jack. Then plug one end
of the supplied long one-line cord into
L3 . Route both
line cords through the left and middle slots on the
mounting bracket.
3. Insert the supplied AC adapter’s barrel plug into AC 9V
on the bottom of the base. Then route the adapter cord
through the right slot on the mounting bracket.
4. Connect the other end(s) of the phone cord(s) to the
phone line wall jack(s) and plug the adapter into a
standard AC outlet.
1
0
"
#
"9
#..
/2
.#6'
1. Place the flat end of the mounting bracket face up and
insert the bracket’s four tabs into the matching slots on
the bottom of the base. Then slide up and snap the
bracket into place.
2. Insert the supplied AC adapter’s barrel plug into AC 9V ,
then route the adapter’s cord through the left slot on the
mounting bracket.
3. If the wall plate has a single two-line phone jack, and
there is a one-line phone jack nearby, plug one end of
the supplied two-line short modular cord into
LINE L1/
L2, and plug the one-line long modular cord into L3 .
Then plug the two-line short modular cord’s other end
into the two-line wall plate jack, and plug the single-line
long cord’s other end into the one-line wall jack.