Radio Shack ET-1755 - Manual (Page 11)

11
2. Write the name or number next to the appropriate
memory location on the provided card. The card has an
upper and lower position for each memory location.
3. Insert the plastic cover’s tabs into the slots on the base,
align the memory buttons with the cover and carefully
press down on the cover to secure it.
75+0)"#0"126+10#."*'#&5'6
Your phone is equipped with a headset jack on the base, so
you can connect an optional headset.
±
1. Insert the headset’s 3 /
32
-inch (2.5-mm) plug into the V
jack on the right side of the base.
2. Place the headset on your head with the earpiece over
either ear and adjust the microphone boom until it is
about even with your chin.
3. Press SPEAKER/HEADSET to make or receive calls.
4. When you finish the conversation, press SPEAKER/
HEADSET to hang up.
6417$.'5*116+0)
We do not expect you to have any problems with your
phone, but if you do, the following suggestions might help.
2TQDNGO" 5QNWVKQP
Low volume or unusual
sounds.
Someone has picked up
another phone on the same line.
Hang up the other phone.
Phone does not work or works
poorly.
Check the TONE/PULSE
setting.
Check the phone line and AC
adapter connections. Only LINE
1 can work as a basic phone
during an AC power failure.
The call is too noisy (static or
interference).
Hang up and redial the number.
All line
indicators light, but there is no
dial tone on any line. Check that the modular cord is
properly connected at both
ends.
±
"016'"
±
"
• Connecting a headset
disconnects the handset’s
earpiece and microphone.
• The headset does not operate
during a power failure.