Radio Shack ET-926 - Manual (Page 6)

6
3. Insert the supplied AC adapter’s
barrel plug into the DC IN 9V jack
on the back of the base.
4. Route the adapter’s cord through
the strain relief slot on the base.
5. Plug the adapter into a standard
AC outlet.
6. Lift the base’s antenna to a verti-
cal position.
Strain Relief
Slot
Mounting the Base on a
Wall Plate
1. Insert the two catches at the top of
the bracket into the upper slots on
the bottom of the base. Then
press the two latches on the sides
of the bracket into the lower slots.
2. Plug one end of the supplied short
modular cord into the TEL LINE
jack on the back of the base.
43-1096.fm Page 6 Tuesday, August 17, 1999 3:47 PM