Radio Shack ET-926 - Manual (Page 11)

11
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work
and you might hear an error tone.
If this happens, return the handset
to the base for a few seconds.
• About once a month, fully dis-
charge the battery pack by keep-
ing the handset off the base until
the Talk/Batt Low indicator
flashes. Otherwise, the battery
pack loses its ability to fully re-
charge.
Note: The security code is not lost
even if the battery pack is com-
pletely discharged.
• If the Talk/Batt Low indicator does
not light and the phone does not
work, recharge the battery pack.
(The battery power might be too
low to light the indicator.)
• If the battery pack becomes weak
during a call, you hear a beep ev-
ery 16 seconds and the Talk/Batt
Low indicator flashes. Recharge
the battery pack.
• The supplied battery pack should
last for about a year. When the
battery pack loses its ability to
fully recharge, order a replace-
ment battery pack from your local
RadioShack store (see “Replacing
the Battery Pack” on Page 21).
SETTING THE DIALING
MODE
Set PULSE-TONE on the back of the
base for the type of service you have.
If you are not sure which type you
have, do this test.
1. Set PULSE-TONE to TONE .
2. Lift the handset, press Talk , and
listen for a dial tone.
3. Press any number other than 0.
Note: If your phone system
requires that you dial an access
code (9, for example) before you
dial an outside number, do not
press the access code either.
If the dial tone stops, you have
touch-tone service. Leave
PULSE-
TONE set to TONE .
If the dial tone continues, you
have pulse service. Set
PULSE-
TONE to PULSE .
43-1096.fm Page 11 Tuesday, August 17, 1999 3:47 PM