Universal Remote Control (URS) MX-500 - Manual (Page 28)

27
3. Press one of the macro buttons, M1-M3, Power or
System Off you wish to store your macro on.
4. Press the functional buttons you wish to store in the
device macro button you selected, in the order you want
them stored. You can store up to 20 commands.
Important: Do not press the MAIN button at the beginning
of your macro, or it will not work. You can use the MAIN
button at any other step in your macro.
5. Be sure to end your macro on the Device page that you
would like it to remain on when the macro is sent in normal
use.
6. Store the commands you programmed into the macro
button by pressing the Channel Up button.
7. Return to Step #3 until you have programmed all of the
Macros that you require.
8. Once you have completed the programming and wish to
exit from this mode, press the MAIN button. Exit from the
SETUP mode by pressing MAIN button once again.
Tip: The M1, M2, M3, POWER and SYSTEM OFF macros
are “system-wide”, meaning they will function the same no
matter what device you are in when you use them.
6. Programming Macro Buttons