Remote commands – Radio Shack TAD-739 User Manual
Page 18
18
Remote Commands
Press:
To:
[0
Set the TAD to not answer
calls for both lines. The TAD
says “Line 1 is off, line 2 is off.”
[1
Set the TAD to not answer
calls only for line 1. The TAD
says “Line 1 is off.”
[2
Set the TAD to not answer
calls only for line 2. It says
“Line 2 is off.”
00
Set the TAD to answer calls
for both lines. It says “Line 1 is
on, line 2 is on.” If no OGM 1
is recorded in line 1, it says
“You have no announcement
one in line 1,” and sounds four
beeps, then says “Line 2 is
on.” If no OGM 1 is recorded
in line 2, the TAD says “Line 1
is on, you have no announce-
ment one in line 2.” then
sounds four beeps.
01
Set the TAD to answer calls
only for line 1. It says “Line 1 is
on.” If no OGM 1 is recorded
in line 1, it says “You have no
announcement one in line 1.”
and sounds four beeps. Press
81[ to record OGM 1.
02
Set the TAD to answer calls
only for line 2. It says “Line 2 is
on.” If no OGM 1 is recorded
in line 2, it says “You have no
announcement one in line 2.”
and sounds four beeps. Press
82[ to record OGM 1.
#0
Set the TAD to announce only
for both lines. It says “Line 1 is
announce-only, line 2 is
announce-only.” If no OGM 2
is recorded in line 1, it says
“You have no announcement
two in line 1.” Then it sounds
four beeps and says “Line 2 is
announce-only.” If no OGM 2
is recorded in line 2, it says
“Line 1 is announce-only. You
have no announcement two in
line 2.” Then it sounds four
beeps.
#1
Set the TAD to announce only
for line 1. It says “Line 1 is
announce-only.” If no OGM2 is
recorded, it says “You have no
announcement two in line 1.”
Press 91[ to record OGM2.
#2
Set the TAD to announce only
for line 2. It says “Line 2 is
announce-only.” If no OGM2 is
recorded, it says “You have no
announcement two in line 2.”
Press 92[ to record OGM2
2, then
line num-
ber (0, 1,
2)
(0 for both
lines, 1 for
line 1, and
2 for line
2)
Play all messages in the
selected line. If no message is
recorded, the TAD says “You
have no messages in line x.”
(where x is the line number). If
no messages are recorded in
both lines, the TAD says “You
have no messages in line 1,
and no messages in line 2.”
Press:
To:
43-739.fm Page 18 Friday, August 13, 1999 2:00 PM