Radio Shack TAD-739 - Manual (Page 11)

11
1. To record the OGM 1 (or OGM 2)
message for each line, hold down
OGM 1 (or OGM 2 ) until the TAD
beeps and both ANSWER indicators
flash.
Notes:
• Proceed next step within 8 seconds.
Otherwise, the TAD sounds a short
beep, and you must start again from
Step 1.
• Recording OGM 2 only does not
turn on the TAD. You must start re-
cording OGM from OGM 1.
2. Press ANSWER above the desired
LINE 1 or LINE 2 , and speak your
message from about 8 inches from
the front of the TAD.
3. When you finish, press STOP . The
TAD beeps and plays back the out-
going message.
Note: When you finish recording
OGM 1 only, the TAD automatically
sets to answer on. The ANSWER in-
dicator above
LINE 1 lights.
Checking the Outgoing
Messages
To check an outgoing message, press
its button (
OGM 1 or OGM 2 ). You see
the announcement number A1 or A2 ,
the TAD beeps and both ANSWER indi-
cators flash. Then press ANSWER within
8 seconds on the selected line and the
message plays after the beep.
If there is no announcement recorded,
you hear “You have no announcement
one (or “two”) in line one (or “two”)”
when you press its button.
SETTING THE NUMBER
OF RINGS
Set each line’s ring select switch to 2 , 4 ,
7 , or TS to set how long the TAD waits
before it answers a call (2 rings, 4 rings,
7 rings or toll-saver).
If you plan to check your messages by
long distance, set the ring select switch
to
TS (see “Using the Toll-Saver” on
Page 17).
43-739.fm Page 11 Friday, August 13, 1999 2:00 PM