On a wall or wall plate – Radio Shack ET-686 User Manual

Page 7

Note: If you connect the phone to a
two-line phone jack with a two-line
cord, do not connect a cord to the

TEL LINE 2

jack or the phone will not

operate properly. Instead, you can
connect another phone device, such
as a fax machine or modem.

To connect the phone to two one-
line phone jacks, plug one end of
the supplied long two-line modular
cord into

TEL LINE 1/2

and plug

another cord (not supplied) into the

TEL LINE 2

jack.

To connect the phone to a single
one-line phone jack, plug one end of
the supplied long modular cord into
the

TEL LINE 1/2

TEL LINE 2

jack.

Note: If you connect the phone to a
single one-line phone jack, do not
press the unused line button or you
might hear feedback.

2. Plug the supplied AC adapter’s bar-

rel plug into the

DC IN 9V

jack on the

back of the base.

3. Route the adapter’s cord through

the strain relief slot on the bottom of
the bracket.

4. Plug the adapter into a standard AC

outlet.

5. Connect the phone cord(s) to the

modular phone line jack(s).

6. Raise the base’s antenna to a verti-

cal position.

On a Wall or Wall Plate

Note: To mount the base directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the bracket. Drill two
holes 3

inches apart. Then thread a

screw into each hole, letting the heads
extend about

inch from the wall.

43-686.fm Page 7 Friday, September 10, 1999 3:13 PM