Radio Shack ET-686 - Manual (Page 21)

21
USING A HEADSET
You can make or answer calls with
hands-free convenience using an op-
tional headset (available at your local
RadioShack store) that has a
3 /
32
-inch
plug.
To connect the headset, pull open the
rubber cover marked
on the side of
the handset, then insert the 3 /
32
-inch plug
into the jack.
Notes:
• Connecting a headset disconnects
the handset’s earpiece and micro-
phone, but it does not affect the ET-
686’s speakerphone.
• VOLUME on the handset also con-
trols the connected headset’s vol-
ume.
• If you place the handset on the base
facedown to recharge it while the
headset is connected, be sure the
handset seats properly.
With a headset connected, you make or
answer calls as usual, using the keys on
the handset.
You can use a handset holder (available
at your local RadioShack store) to hang
the handset on your belt for greater con-
venience.
When you finish using the headset, dis-
connect it from the handset and close
the rubber cover to protect the jack.
43-686.fm Page 21 Friday, September 10, 1999 3:13 PM