Radio Shack AFX-300 - Manual (Page 14)

14
2. Plug the adapter’s other end into a standard 120-volt AC
power outlet.
Caution: You must use a Class II, 120V AC/12V DC
adapter that delivers at least 400 milliamps. Its center tip
must be set to negative and its plug must correctly fit the
AFX-300’s
DC 12V jack. The supplied adapter meets
these requirements. Using an adapter that does not meet
these requirements could damage the AFX-300 or the
adapter.
3. Wait about 10 seconds, then unplug the adapter’s barrel
plug from the AFX-300’s DC 12V jack.
4. Wait another 10 seconds, then reconnect the adapter’s
barrel plug to the AFX-300’s DC 12V jack.
5. Route the AC adapter cord through the AFX-300’s strain
relief slot.
OPEN
RESET
AC
ADAPTER
43-1245.fm Page 14 Wednesday, August 18, 1999 9:51 AM