beautypg.com

Radio Shack 61-3005 User Manual

Installing your wall switch, Setting up your wall switch, What’s included

background image

Please read this User’s Guide before

installing, setting up, and using your new product.

www.radioshack.com

Thank you for purchasing the RadioShack Home

Automation Wall Switch. Your Wall Switch is

designed to control incandescent lights only,

with rating between 40W and 500W. It replaces

your existing switch, and controls both indoor

and outdoor ceiling lights. A push button is

provided for local on/off control.

Turn the power back on at the circuit

breaker panel.

 Push the button to turn your wall switch

on or off.

installing your wall switch

61-3005

home automation

wall switch

operating your wall switch

©2004. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are
trademarks used by RadioShack Corporation.

61-3005

06A04

Printed in China

Turn the power off at the circuit breaker

panel.

Remove your wall plate and unscrew

the existing switch from its box.

Disconnect the wiring from your

existing switch, and connect the two

wires on your new switch using the

wire nuts provided.

Screw the switch into its wall box.

WARNING: To reduce the risk of fire or shock hazard, do not expose this
product to rain or moisture.

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.

This symbol is intended to alert you to the presence of
uninsulated dangerous voltage within the product’s enclosure
that might be of sufficient magnitude to constitute a risk of
electric shock. Do not open the product’s case.

This symbol is intended to inform you that important
operating and maintenance instructions are included in the
literature accompanying this product.

Set the House Code

dial to the same letter

that you set on your

Controller.

 Set the Unit Code

dial to an unused code.

Turn the ON/OFF

switch beneath the

push button to ON

(center position).

Replace the wall plate

on your wall box.

setting up your wall switch

Note

Be sure no loose wires are protruding;
use insulating tape (not provided) to
cover the wire nuts, if necessary.

Warning

Wall switches must not be used to
control appliances, low voltage lamps
or fluorescent lamps!

2 screws

2 wire nuts

wall switch

user’s guide

what’s included

Note

When replacing a light bulb, turn
your wall switch to OFF
(left position).

Wire nuts

Screws

Wall Switch

Wires

Push

button

ON/OFF