Radio Shack ET-925 - Manual (Page 7)

7
4. Route the adapter’s cord through
the strain relief slot on the base.
5. Plug the adapter into a standard
AC outlet. The POWER indicator
on the base lights.
6. Lift the base’s antenna to a verti-
cal position.
Mounting the Base on a
Wall Plate
1. Plug one end of the supplied short
modular cord into the TEL LINE
jack on the back of the base.
Strain Relief
Slot
2. Route the modular cord through
the upper groove on the bottom of
the base.
3. Insert the supplied AC adapter’s
barrel plug into the DC IN 9V jack
on the back of the base.
4. Route the adapter’s cord through
the right side of the strain relief
slot on top of the base and
through both the upper and lower
grooves on the bottom of the
base.
Upper
Groove
Strain Relief
Slot
Upper
Groove
Lower
Groove
43-1095.fm Page 7 Tuesday, August 17, 1999 3:37 PM