Radio Shack ET-925 - Manual (Page 17)

17
3. When the service answers, press
TONE/ . Any additional numbers
you dial are sent as tone signals.
4. After you complete the call, return
the handset to the base, press
TALK , or press SPEAKER . The
phone automatically resets to the
pulse mode.
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, hold down
PAGE on
the base for at least 2 seconds. The
handset beeps for 1 minute. To stop it
from beeping before it automatically
stops, press
TALK on the handset (or
SPEAKER on the base) twice.
Notes:
• Make sure you press TALK or
SPEAKER twice to stop the hand-
set from beeping. If you press
TALK or SPEAKER only once, you
get a dial tone.
• If you press PAGE for less than 2
seconds, the handset beeps for
only 2 seconds.
• If you receive a call while the page
is sounding, the handset stops
beeping and the handset and base
start ringing.
MEMORY DIALING
You can store up to 20 numbers in the
ET-925’s memory (10 in the handset’s
memory and another 10 in the base’s
memory), then dial a stored number by
pressing
MEM then a one-digit memory
location number.
Storing a Number in Memory
Notes:
• The phone beeps 5 times and exits
the programming mode if you wait
more than 20 seconds between
key presses.
• You cannot dial the number stored
in one memory (base or handset)
using the keypad on the other.
43-1095.fm Page 17 Tuesday, August 17, 1999 3:37 PM