Radio Shack TAD -797 - Manual (Page 33)

33
USING REMOTE
COMMANDS
Follow these steps to operate the TAD
from a remote location.
Nots: If you wait more than 20 seconds
between each keypress, the TAD
sounds a long beep and hangs up.
1. Dial your phone number and wait for
the TAD to answer.
Note: Even if the TAD is not set to
answer calls, it will answer after
about 10 rings and sound a series of
beeps.
2. When the outgoing message begins
(or the TAD sounds a series of
beeps), press
# , then enter your PIN
within 2 seconds.
If the PIN is correct, the TAD an-
nounces the day and time, then it
announces the number of messag-
es. The TAD beeps about once ev-
ery two seconds to let you know it is
ready to accept remote commands.
3. To use a remote command, press #
and (within 2 seconds) the number
for the command you want.
Press
# then:
To:
1 Repeat current message
during playback.
2 Play messages.
3 Skip current message dur-
ing playback.
4 Delete current message
during playback.
5 Stop playback, recording,
and room monitoring.
6 Set the TAD to answer calls.
7 Record a memo, or stop
recording a memo.
8 Record or stop recording a
new outgoing message.
9 Set the TAD to not answer
calls.
Monitor the room where the
TAD is located for 15 sec-
onds.
43-797.fm Page 33 Monday, August 16, 1999 9:20 AM