Radio Shack TAD -797 - Manual (Page 10)

10
7. Press and lift out the handset hold-
er, flip it over as shown, then snap it
back into place so it holds the hand-
set.
8. Lift the base’s antenna to a vertical
position.
Directly on the Wall
For this mounting method, you need two
screws (not supplied) with heads that fit
into the keyhole slots on the bottom of
the base.
1. Drill two holes 3 15 /
16
inches (100 mm)
apart. Then thread a
screw into each hole,
letting the heads ex-
tend about
5 /
16
inch (8
mm) from the wall.
2. Insert the bracket’s tabs into the
base’s lower tab slots as shown,
then press down on the bracket’s
clips and insert them into the lower
clip slots.
5 / 16 "
3 15 / 16 "
Tabs
Lower
Lower Clip Slots
Tab Slots
4. Route the adapter cord through the
narrow groove on the bracket.
5. Plug the modular cord’s other end
into the wall plate jack, then align
the bracket’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
6. Plug the adapter into a standard AC
outlet.
Narrow
Groove
43-797.fm Page 10 Monday, August 16, 1999 9:20 AM