Renesas H8S2215R User Manual

Page 16

• Confirm the settings shown and press .

HMon will attempt to connect to the RSK. If it succeeds then the Output window in HEW will show the ‘Connected’ message. In this case

please proceed to Chapter 6.

If the connection fails you will be returned to the previous dialog with the ‘Abort’ button enabled. This is likely to be caused by a connection

error with the RSK and the E8. It can also be caused if the RSK has not got a working copy of the HMon target code programmed. Check

the settings and if all settings are OK but the connection still fails then a Boot Mode download will be required. Press .

• In the “Connection Error” dialog box, select

‘Download HMon using Boot Mode’.

• Press .

Click to any warning dialogs. Click in Boot Mode pin configuration dialog.

You will be presented with “Select USB Device” dialog box.

Warning:

Please ensure that the RSK is powered before connecting a USB cable to the USBDirect port. Failing to do this may

damage the board.

Connect another USB cable to the ‘USB’ connector on the RSK and spare USB port on your PC.

If this is the first time you are connecting the USBDirect port to the PC, you need to install the driver required for USBDirect. Follow the

steps given on the screen to install the driver.