RCA 2-9398 - Manual (Page 4)

2
M
ODULAR
J
ACK
R
EQUIREMENTS
You need an RJ11 type modular jack, which is
the most common type of phone jack and might
look like the one pictured here. If you don’t have
a modular jack, call your local phone company to
find out how to get one installed.
G
ETTING
S
TARTED
This section shows you how to install and setup your Caller ID Telephone.
It’s important that you follow the instructions in this section in order to get
your new phone correctly installed and set up.
B
EFORE
Y
OU
B
EGIN
P
ARTS
C
HECKLIST
Your package should contain the following items:
Handset AC power supply
(# 5-2381) Handset cord Line cord
P
OWERING THE
C
ALLER
ID T
ELEPHONE
This unit is designed to be powered by the
AC adapter. When using AC power, a 9-volt
battery acts as a backup, enabling
continuous operation of full telephone and
Caller ID features for up to 4 hours and 30
hours of only Caller ID signal reception in
the event of power failure.
If you are planning to use both the AC
adapter and battery, you should install the
9-volt battery before you begin the
telephone installation procedure.
FLASH PAUSE ALARM
1 2 ABC 3 DEF
4 GHI 5 JKL 6 MNO
7 PRS 8 TUV 9 WXY
TONE 0 OPER # SPEAKER
- VOL + MUTE
MENU
BUSY/REDIAL
DN DISTURB
HOLD
STORE LOWER
NEW
CALL
REVIEW DIAL DELETE
CALLER ID
Base unit