Radio Shack ET-521 - Manual (Page 21)

21
To stop the handset from beeping before
it automatically stops, press
TALK on the
handset twice or PAGE on the base.
To answer a page from the base or to
page the base, press
INTCM on the
handset. The base sounds three beeps
and
Intercom appears on the hand-
set. Begin your conversation.
Notes:
• You cannot speak and hear the
other party at the same time during
an intercom conversation.
• You cannot page the handset during
a call.
• If you want to make an intercom call
during a phone conversation, press
INTCM on the handset to page the
base. Phone hold Intercom
appears and the call is placed on
hold. When you finish the intercom
call, press
INTCM to resume the
phone conversation.
• If a phone call comes in during an
intercom conversation, press TALK
on the handset to answer the call.
When you finish the call, you can
press
INTCM to resume the intercom
conversation.
To end the intercom conversation, press
INTCM .
MEMORY DIALING
You can store up to 20 phone numbers
and names in memory, then dial a stored
number by pressing a two-digit memory
location number.
Each stored number can be up to 24 dig-
its long, and each name can contain up
to 16 characters.
Storing a Number and Name in
Memory
Notes:
• If T/P is set to P and you want to use
tone dialing for a memory number,
you must store a
as the first entry
of the number you want to tone dial.
• Do not store a number with both
pulse and tone entries in the same
memory location. This could result
in a wrong number being dialed.
• Each pause (see “Entering a Pause”
on Page 23) and tone entry ( )
uses one digit of memory.
• To keep your accounts secure, we
recommend you do not store your
personal access code for services
such as bank-by-phone in a memory
location.
• An error tone sounds and the phone
exits the programming mode if you
wait more than 15 seconds between
each keypress or enter more than
24 digits. You must start over at
Step 1.
43-1021.fm Page 21 Tuesday, August 17, 1999 9:14 AM