beautypg.com

Chapter 1: connections & setup, Things to consider before you connect, Protect against power surges – RCA Scenium LCDX3022W User Manual

Page 7: Protect components from overheating, Important stand and base safety information, Use indirect light, Connection illustrations, Check supplied parts, Chapter 1 3, Insert each cable firmly into the designated jack

background image

Chapter 1: Connections & Setup

Chapter 1

3

Graphics contained within this publication are for representation only.

Things to Consider Before You Connect

Protect Against Power Surges

Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug
your TV into an outlet that is controlled by a wall switch.

Turn off the TV and/or component(s) before you connect or disconnect any cables.

Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards Instructions at the
beginning of the manual.

Protect Components from Overheating

Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

Don’t stack components.

If you place components in a stand, make sure you allow adequate ventilation.

If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around
other components.

Important Stand and Base Safety Information

If a stand or base is used ensure that is of adequate size and strength to prevent the TV from being accidentally tipped
over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety
Instructions at the beginning of the manual.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.

Use Indirect Light

Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.

Connection Illustrations

The components used in the connection illustrations are for representation only. The input jacks and the output jacks
on the back of your components (VCR, DVD player, etc.,) might look different than those illustrated.

Check Supplied Parts

Check that the following parts were packed with your product.

ON-OFF

TV

DVD

VCR

AUX

AUDIO

SAT

PIP+

SKIP

PIP

SWAP

ZOOM

PIP-

FREEZE

PRESETS

CLEAR

DISC MENU

INFO

MENU

GUIDE

OK

MUTE

MUTE

GO

BACK

GO

BACK

VOL

VOL

CH

INPUT

INPUT

ANTENNA

ANTENNA

0

0

2

2

5

5

1

1

4

4

7

7

8

8

3

3

6

6

9

9

PLAY

PLAY

FORWARD

FORWARD

REVERSE

REVERSE

STOP

STOP

PAUSE

PAUSE

RECORD

RECORD

SLEEP

ZZZ

ZOOM-

ZOOM+

c

i

M

learning

LIGHT

CAB

/

/HD

Remote Control

2 AA batteries

Power cord

3.5mm mini phone

to audio cable adapter

(use with the RGB Audio

In jack, not the

headphone jack)

16278190.01 Connections

4/13/04, 4:32 PM

3