RCA 9V345T - Manual (Page 3)

Chapter 1: Getting Started
1 Graphics contained within this publication are for representation only. Your unit might differ slightly.
Connect your TV
Two possible connections are shown below.
Connect the cable from your cable system or off-air antenna to the ANTENNA jack on the
back of the TV, as shown on the left.
TV (Back Panel)
ANTENNA
ANTENNA, CABLE, CABLE BOX OR VCR
S-VIDEO
OPTICAL
COAXIAL
AUDIO OUT
L
L
R
R
1
2
VIDEO OUT
1
2
DIGITAL AUDIO OUT
ANTENNA
DVD
PLAYER
RF
MODULATOR
CABLE
OR
OFF-AIR
SIGNAL
Y
P B
P R
L V ANT IN
TO TV
R
ANTENNA IN FROM TV
DVD Player + TV with RF modulator
Use the RF modulator (included with AC power supply) to connect your DVD player. (The
example shows jacks on one side of the RF modulator for reference. The modulator actually
has jacks on both sides.)
1. Connect the audio cables to the AUDIO OUT jacks on the back of your DVD
player and to the corresponding Audio Input jacks on the RF modulator.
2. Connect the video cable (yellow) to the VIDEO OUT jack on the back of your
DVD player to the Video Input jack on the RF modulator.
3. Connect the RF modulator to the back of the TV.
4. Connect the cable from your cable system or off-air antenna to the ANT-IN jack
on the RF modulator.
RF
MODULATOR
L V ANT IN
TO TV
R
ANTENNA IN FROM TV
9 V D C 80 0m A
5. Select channel 3 or 4 on the RF
modulator. When you turn the TV on, the
RF modulator will automatically detect
your cable input for the TV. Channel 3 or
4 (which ever you choose) will play your
movie.
Important Stand and Base Safety Information
Choose the location for your TV carefully. Place the TV
on a stand or base that is of adequate size and strength
to prevent the TV from being accidentally tipped over,
pushed off, or pulled off. This could cause personal
injury and/or damage the TV.
16394960.01 5/10/04, 5:23 PM 1