Activating/deactivating the services, De)activating services on your telephone, Chapter 4 – RCA SpeedTouchTM706 User Manual
Page 52
44
E-DOC-CTC-20051017-0148 v1.0
Chapter 4
Voice over IP
Activating/Deactivating
the services
Before you can use a telephony service, the service needs to be activated. This
might have been done during the initial setup of your SpeedTouch™.
If not, you can activate or deactivate a particular telephony service:
on the SpeedTouch™ Web pages: see
“ (De)activating services on the Web
.
by dialling the activation code on your telephone: see
.
(De)activating services
on the Web pages
Proceed as follows to activate a service on the Web pages:
1
Go to the SpeedTouch™ Web pages.
2
In the menu, select Toolbox > Telephony.
3
In the upper right corner, click Configure.
4
In the Pick a task list, click Configure telephony services.
A list of telephony services provided by your Service Provider appears:
5
Select the services you want to activate.
6
Click Apply.
(De)activating services
on your telephone
Proceed as follows to activate a service using the attached telephone:
1
Take the phone off the hook.
2
Dial an ‘*’ followed by the activation code. If you dial a ‘#’ after the activation
code, the service will be activated instantly.
3
Wait for the confirmation tone, and place the phone on the hook.
To deactivate the service, clear the corresponding check box.
The activation code depends on your provider’s configuration. The
activation codes can be found on the Telephony Services Web page.
To deactivate the service, dial a ‘#’ followed by the activation code.
The Forced FXO service cannot be activated on your phone.