To configure wds, Chapter 2 – RCA SpeedTouchTM706 User Manual
Page 38
30
E-DOC-CTC-20051017-0148 v1.0
Chapter 2
Local Network Setup
To configure WDS
Proceed as follows:
1
Go to the SpeedTouch™ Web pages.
2
In the menu, select Home Network.
3
Click your WLAN.
4
In the upper right corner, click Configure.
5
On the Wireless Access Point page, in the Pick a task list, click Configure WDS.
6
Select WDS Enabled.
7
In the Pick a task list, click Scan for wireless access points.
A warning is displayed.
8
Click OK.
The SpeedTouch™ scans for access points on the same radio channel.
9
Select your repeater in the List of Accessible Access Points, and then click
Apply.
If not already done, set a
fixed
channel and check whether the security
settings (WEP encryption or no encryption) on your SpeedTouch™ are
the same as on the repeater.