Radio Shack ET-1101 - Manual (Page 7)

7
3. Plug the supplied AC adapter’s barrel
plug into the DC 12V 500mA jack on
the back of the base.
4. Plug the adapter into a standard AC
outlet.
5. Lift the base’s antenna to a vertical
position.
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-1101 comes with a rechargeable
nickel-cadmium battery pack. You must
connect the battery pack and charge it for
at least 15 hours before you use the
phone.
To connect the battery pack, line up the
slots on the battery pack with the posts on
the back of the keypad. Press down and
slide the battery pack forward until the
latch clicks.
To charge the battery pack, place the
keypad in the front charging slot on the
base. The
CHARGE/IN USE indicator on
the base lights.
To charge a spare battery pack, place it in
the rear charging slot with its latch end
facing down and its contacts toward the
rear of the base. The CHARGE indicator
lights.
Spare battery packs (RadioShack Cat.
No. 23-810, not supplied) are available at
your local RadioShack store.
Recharge the battery pack when the LOW
BATT indicator on the keypad flashes.
Rear
Charging
Slot Front
Charging
Slot
LOW BATT
Indicator
43-1101.fm Page 7 Friday, July 9, 1999 9:32 AM