Remington ST3010A - Manual (Page 15)

REMINGTON® ELECTRIC TRIMMER | 11
118336
6 troubleshooting
WARNING: Use of non-Rem-
ington® parts or accessories may
cause personal injury or damage
to the unit.
OBSERVED FAULT POSSIBLE CAUSE REMEDY
Motor does not run when you turn trig-
ger switch on.
1. Extension cord connection is loose. 1. Check cord connection at electri-
cal outlet and at rear of trimmer.
Line does not feed when you tap the
line advance button.
1. All line has been used on spool.
2. Line has retracted into spool.
3. Line is caught or tangled on spool
and will not feed.
1. Install new line on spool, follow-
ing steps under Replacing Trimmer
Line, page 7.
2. Remove spool and pull line out,
then replace spool.
3. Remove spool, loosen and un-
tangle line, then replace spool.
Part Number Description
RS65A Replacement Spool
with Line
Note: For additional help, visit our
technical service web site at
www.desatech.com.
WARNING: Unplug trimmer from power source before servicing.
Severe injury or death could occur from fire, electrical shock, or rotating line.
Technical Service
You may have further questions about
assembling, operating, or maintain-
ing this trimmer. If so, you can vis-
it our Technical Service web site at
www.desatech.com or contact our
Technical Service Department at 1-800-
858-8501 (English only). You may also
write to:
DESA Specialty Products™
ATTN: Technical Service Specialty
Products
P.O. Box 90004
Bowling Green, KY 42102-9004
When contacting DESA Specialty Prod-
ucts™, have ready
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt
for written requests)
Replacement Spool