Remington ST3010A - Manual (Page 12)

8 |
118336
Chapter 4: Trimmer Operation
4. Remove the line retaining ring from
the spool (see Figure 4-13).
5. Measure out 30 feet of replacement
line.
6. Push one end of the new line through
the left line mounting hole on the
spool (see Figure 4-14).
7. Feed 15 feet of the line through this
hole. Feed the other 15 feet of line
through the right line mounting hole
(see Figure 4-15). Pull the line tight
(see Figure 4-16).
Figure 4-13: Removing line retaining ring
Figure 4-14: Inserting line in left hole
Figure 4-15: Inserting line in right hole
Figure 4-16: Pulling line tight
Line Retaining
Ring
Direction of
Line Feed
Direction of
Line Feed
Direction of
Line Feed
Figure 4-17: Arranging line into spool
Figure 4-18: Placing upper spool line into retaining ring
Retaining
Slot
8. Lay the line from the left mounting
hole into the upper spool section. Lay
the line from the right mounting hole
across the other line. Insert this line into
the retaining slot between the upper
and lower spool section, then lay the
line into the lower spool section. See
Figure 4-17 for proper line placement.
9. Place the line from the upper spool
section through the line retaining ring
(see Figure 4-18).
10. Place the line retaining ring back on
the spool (see Figure 4-19).