Using the timer, Troubleshooting care – Radio Shack 13-1317 User Manual

Page 6

•

J?C;H

flashes.

• Clock

1. When clock is shown, hold down

CLOCK /MEMORY

for more than three

seconds until

'(>

(*>

flashing is

displayed.

2. Press

)

-ý

to choose between the

12-hour mode or 24-hour mode.

3. Press

CLOCK /MEMORY

button again to

save. The hour digits flash on the
display.

4. Repeatedly press or hold down

)

to select the hour.

5. Press

CLOCK /MEMORY

again to save.

The minute digits flash.

6. Repeatedly press or hold down

)

to select the minutes.

7. Press

CLOCK/MEMORY

once more to

save. Clock is set.

75+0)"6*'"6+/'4

'66+0)

6*'

+/'4

The timer acts as an alarm clock, powering
on the stereo in the last listening mode.
Once the timer is set, it will come on at the
same time everyday.

1. Hold down

SLEEP/TIMER

for more than

three seconds until

J?C;H

flashes on the

display.

2. Hold down

CLOCK/MEMORY

for more

than three seconds until the hour digits
flash.

3. Repeatedly press or hold down

)

to select desired hour.

4. Press

CLOCK/MEMORY

again to save.

The minute digits flash.

5. Repeatedly press or hold down

)

to select the minutes.

6. Press

CLOCK/MEMORY

once more to

save.

J?C;H

flashes for a few more

seconds then stops flashing. Then the
timer is set.

+/'4

When it is time for timer-on, and the unit is in
standby mode, the stereo will automatically
turn on in the last listening mode. Playing
volume will be at the previously set levels.

If you wish to snooze for some more time,
press

SNOOZE

, the unit will be turned off for

five minutes. Five minutes later, it will start to
play again automatically.

Timer turns off automatically one hour later.
After timer-off,

SNOOZE

can not be initiated.

740+0)

((

6*'

4'5'6

+/'4

To turn off the timer, press

TIMER

on the

remote or, hold down

SLEEP/TIMER

on the

stereo for more than three seconds until

J?C;H

disappears.

To turn on the timer, press

TIMER

on the

remote or, hold down

SLEEP/TIMER

on the

stereo for more than three seconds until

J?C;H

flashes.

5+0)

6*'

.''2

+/'4

The stereo can be set to turn off
automatically, so that it does not continue
playing after you have gone to sleep. To set
a “sleep time”, press

SLEEP

repeatedly until

the desired time is shown on the display.
The maximum sleep time is 90 minutes. The
setting decreases by 10 minutes every time
you press

SLEEP

. To cancel the sleep

setting, press

SLEEP

repeatedly until

IB;;F

disappears.

6417$.'5*116+0)

If your system is not working properly, these
suggestions might help you to eliminate the
problem. If you still have a problem, take it to
your local RadioShack store for assistance.

%#4'

Keep the stereo dry. If it gets wet, wipe it dry
immediately. Use and store the stereo only
in normal temperature environments.
Handle the stereo carefully; do not drop it.
Keep the stereo away from dust and dirt,
and wipe it with a damp cloth occasionally to
keep it looking new.

"016'"

Setting the Clock

In 12-hour mode,

appears for an AM hour

and

appears for a PM hour.

Timer-On

If the last listening mode was the CD player,
play will start from the first track.

2TQDNGO

5QNWVKQP

The set does not
function.

Confirm the connection
of the AC power plug to
a working AC outlet.

No Sound

Check the speaker
connections.

Adjust the volume.

CD does not play

Reinstall the CD with its
printed side (label side)
facing out.

Clean or replace the
CD.

Press FUNCTION to
switch to CD mode.

Noisy or distorted
radio reception

Tune the station in
again.

Adjust the position of
the stereo for best
reception

The tape does not
advance.

Re-load the tape with
the exposed side down.

Carefully take the tape
out, and insert a
replacement.

Tape deck does not
record.

Verify the tape has
protection tabs. If tabs
have been removed,
replace tape or cover
holes with adhesive
tape.

"%#76+10"

You might permanently damage your speakers
by cleaning them with a vacuum cleaner. Use a
feather duster or a soft loose cloth instead.