Network Technologies SM-nXm-15V-LCD - Manual (Page 28)

NTI VEEMUX VIDEO MATRIX SWITCH
24
Output Names
From the Administration menu, the Output Names page can be
displayed. This page enables the Administrator to change the
names of the output ports displayed on the Switch page. To
change an Output Name, enter the name of the port for the desired
output port number, and press "Save".
Figure 17- Output Port Names
Outputs Scanning Sequences
The Outputs Scanning Sequences page displays the
configuration of an automatic switching sequence from
input (video source) to input for each output (monitor).
The page displays:
ƒ output number being configured
ƒ the Scanning Sequence function status for
that output
ƒ the Scan Mode status of each input
(ON/OFF)
ƒ the length of time in seconds (dwell time) that
each input will be viewed when connected
The output selection at the top of the page can be
changed to any output to display the Scan Sequence
Input selections and dwell times for that output.
The inputs and the amount of time that each will be
viewed (0-32000 seconds) can be set to cycle
sequentially for each connected output. If an input is
set to 0 seconds, the sequence status will display
“OFF”, and the input will be omitted from the scanning
sequence. To include an input in the sequence, enter
a dwell time period from 1-32000 seconds, and press
Apply .
Figure 18- Outputs Scanning Sequences page
To quickly clear all dwell time settings, press the
Clear All button at the bottom of the page. All sequence settings will change to
“OFF” and all dwell time settings will change to 0.