Config – save and restore – N-Tron 9000 Series User Manual
Page 72
5/17/2007 page 72 of 138
Config – Save and Restore
The Config section of the web management gives an administrator the ability to save a running
config into the NVRAM. This step is needed in order for the switch to remember any changes after a power
cycle. The Reset factory default button will reload N-Tron’s factory default configuration settings. Doing
so will re-configure the 9000 Series switch to factory defaults.
In many cases it is desirable to restore factory defaults except retaining IP, Slot Configuration, Subnet
Mask, and Gateway Address. A choice is provided to this end.