Nokia 21XX - Manual (Page 5)

5
Display 1 – Serving cell info
++++++++++++++ ##############
+abbb ccc ddd+ #CH RxL TxPwr#
+ e ff g mmmm+ #TS TA RQ RLT#
+ nnn ppp+ # C1 C2 #
+ oooo + # CHT #
++++++++++++++ ##############
a H, if carrier numbers are scrolled when hopping is on. Otherwise ' '.
bbb When mobile is on a TCH :
DCH carrier number in decimal.
When mobile is NOT on a TCH :
CH means carrier number in decimal.
If hopping is on, used channels are scrolled when display is updated.
ccc rx level in dBm, minus sign is not shown if <=-100
ddd tx power level. If transmitter is on, symbol * is shown in front of the
power level value.
e Time Slot, range is 0 - 7
ff Timing advance, range is 0 – 63
g RX quality (sub), range is 0 - 7
mmmm Radio Link Timeout value. If value is negative, 0 is shown.
Maximum value is 64. When mobile is NOT on TCH then xx is shown.
nnn value of the path loss criterium (C1). Range is -99 - 999.
oooo type of current channel (TCH := Traffic Channel):
THR0 : TCH HalfRate (HR) subchannel 0
THR1 : TCH HR subchannel 1
TFR : TCH FullRate (FR)
TEFR : TCH EnhancedFullRate
F144 : TCH FR data channel, speed 14.4 kbps
F96 : TCH FR data channel, speed 9.6 kbps
F72 : TCH FR data channel, speed 7.2 kbps
F48 : TCH FR data channel, speed 4.8 kbps
F24 : TCH FR data channel, speed 2.4 kbps
H480 : TCH HR data channel, speed 4.8 kbps, subch 0
H481 : TCH HR data channel, speed 4.8 kbps, subch 1
H240 : TCH HR data channel, speed 2.4 kbps, subch 0
H241 : TCH HR data channel, speed 2.4 kbps, subch 1
FA : TCH FR signalling only (FACCH) channel
FAH0 : TCH HR signalling only (FACCH) channel, subch 0
FAH1 : TCH HR signalling only (FACCH) channel, subch 1
SDCC : SDCCH
AGCH : Access Grant CHannel
CCCH : one of the Common Control CHannels
CBCH : CCCH and cell broadcast receiving on
BCCH : Broadcast Control CHannel
SEAR : SEARCHing for available networks
NSPS : MS is in ’No Service, Power Save’ state
ppp value of the cell reselection criterium (C2).
Range is -99 to 999. If phone is phase 1 then C1 value is shown.