NEC PF32W503 - Manual (Page 5)

TURNING THE POWER ON/OFF
The following describes how to turn the TV on/off using the main
switch and the remote control.
< To turn the power on/off >
1. Press the main power switch.
The power indicator lit up red or amber.
In displays the standby mode that the power indicator lit up red.
2. If no picture appears, press the “POWER ON/OFF, PR y / x , direct
select buttons(0~9)”. By pressing the number(one digit only) where
the program you want to watch is preset, you can turn on the set
program selection at the same time. When the TV is on, the power
indicator will lit up amber.
M When the remote control is not at hand, you can turn on the set by
pressing the PR
y / x and standby / on buttons on the TV set.
3. Adjust the sound volume with the C / B buttons in receiver or remote
control.
4. To switch to the standby mode, press the POWER ON/OFF button.
At the same time the power indicator is lit up red.
5. To turn off completely, press the main power switch. At the same time
the power indicator is turned off.
M If you don’t use the TV set for a long time, turn off completely by
using the main power switch on the TV set. You can decrease
unnecessary power consumption.
M When you turn off completely by using the main power switch,
Sleep Time and Timer setting are cleared.
AUTO-POWER-OFF
If TV broadcast for a day is finished, the TV will automatically turn off
after about 30 minutes. However, if the Off -time or Sleep time is
operating, it takes precedence. This Auto-Power-Off feature does not
operate in the VIDEO mode.
LAST-MODE-MEMORY
Settings of picture and sound conditions and preset programs are stored
in the memory even after turning off the power, therefore, next time the
power is turned on, the system will function in the last setting modes.
8
Turning the power on/off
TURNING THE POWER ON/OFF
M The following describes how to turn the TV on/off using the main switch and the remote control.
VOLUME
9
AUTO SETUP SYSTEM
1. Press the MENU button to select
to INSTALL.
2. Press the C / B buttons and then
INSTALL SYSTEM.
3. Select AUTO SETUP with the
PR y / x buttons and the C / B
buttons to start AUTO SETUP.
M NOTE
Press the C / B buttons and keep it
pressing for 2seconds, the AUTO
SETUP will be started.
4. Please wait until the EDIT menu
appears.
M Warning
This television has been factory pretuned to channels 2, 7, 9, 10
and 28. If the auto search function is activated, these preset
channels will be deleted and new channels tuned to 1, 2, 3 ETC..
TILT
When the TILT is selected, the screen will be tilted.
If the picture is tilted, please adjust by using following steps.
1. Press the MENU button to select
INSTALL.
2. Press the PR y / x buttons and
then INSTALL SYSTEM.
3. Select TILT with PR y / x buttons
and C / B buttons to change the
TILT value.
TUNING THE TV CHANNELS
Auto setup system